Category:How-to -> Convert a prefab fireplace

Converting a prefab or zero clearance fireplace to produce more heat

You’ll find some other long posts in our Fourms about the subject, but here is a summary to make it easier….

Two choices:

1. Most economical – buy a fireplace insert that BOTH fits and is approved for use in pre-fab fireplace – line chimney to the top with new stainless liner and connect to stove.
2. Other: Rip out ENTIRE assembly, firebox and chimney and replace with new metal chimney and stove or built-in high efficiency fireplace

You cannot take just any old stove and place it in front or in and pipe up. It must be an insert approved for such use. This is because of two reasons –

first: the chimney in many prefabs is not tested with anything other than the open fireplace and is not as heavy duty.
second: there is wood in the walls a few inches from your fireplace and a stove in front – and it’s pipe – will not meet the required clearances.

Categories:

• How-to
  • Convert a prefab fireplace