Chain/Bar oil

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.

NextEndeavor

Burning Hunk
Jan 16, 2011
248
Southern Iowa
At 10 degrees my Stihl oil (orange jug) is so thick it doesn't want to pour. Went to Stihl dealer today to purchase the cold weather oil in a blue jug. They had it. Just ready to head for cash register when the their main maintenance guy talked me out of it unless cutting below zero. He recommended just keep the bottle in the house or vehicle so it will pour easier. Apparently the blue oil can burn up the chain/bar at 10 degrees and warmer? So I saved $15.
 
  • Like
Reactions: ScotO
Good to know!

I know if the saw is warm the chain oil in the saw is warm ;)

Thanks
 
  • Like
Reactions: ScotO
All of my saws,fuel mix,bar oil etc stay in unheated shed year round.Normally around mid November or so I move the oil to inside semi-heated garage/shop that's underneath part of main floor of house.If its -20 outside,with the furnace it rarely gets below 45 in there.
 
  • Like
Reactions: ScotO
I'll just not store the bar oil in the unheated shed before cutting when cold out. Zero isn't all that common here, maybe a week or so of it each winter. Last year our coldest night was three, once. And if its -20, it's 78 in the stove room where I'll be. Wonder what oil the folks way up north use?
 
Yeah, at 10 degrees outside I am staying inside. Doubt I would even go hunting when it is 10 degrees outside, much less cutting firewood, when the house is nice and toasty.
 
I keep my saws and liquids in a heated garage this time of year, but that still doesn't solve the problem. If I go cutting for a while in 20::F, I still have viscosity issues, so I do use the winter weight oil.
 
In the winter I keep the bar and chain oil in the basement (where it doesn't get below 40-45 degrees) In really cold weather I'll use some 5w-30 through the saw until the saw get's good and warm. After that, I put the regular bar and chain oil in it, which resides in the truck while at the jobsite....
 
  • Like
Reactions: Thistle
At 10 degrees my Stihl oil (orange jug) is so thick it doesn't want to pour. Went to Stihl dealer today to purchase the cold weather oil in a blue jug. They had it. Just ready to head for cash register when the their main maintenance guy talked me out of it unless cutting below zero. He recommended just keep the bottle in the house or vehicle so it will pour easier. Apparently the blue oil can burn up the chain/bar at 10 degrees and warmer? So I saved $15.
I run Canola Oil (Wesson) all year, the consistency stays the same in the summer or winter.
 
When it gets below freezing I do keep the oil inside. I've never used the winter oil. I remember a few guys used to mix some kerosine with their oil in the winter. I never tried it.
 
I helped a friend buck up a downed oak last winter. He had just purchased a new 445 Husqvarna and I noticed while we were cutting his bar was literally smoking. He shut the saw off and I looked it over. Chain tension seemed right, chain was sharp enough and it spun easily along the bar. We started cutting again and more smoke. I asked him what bar oil he was running and he went to his truck and pulled out winter blend Stihl oil. Apparently the dealer advised he use that oil cause it was "winter". In my area average winter high's are in the 30's and the day we cut was probably in the 40's. I dumped the oil out of his tank, which poured out like water, and refilled with my regular bar oil. The smoking stopped and we continued to cut.
 
I run the left over engine oil I have around the shop. Mix of straight 30 weight some 5w and 10w, mostly synthetic. The newer synthetics coat really well and seem to be treating mt well. When this is gone ill probably go to some bulk veggie oil as well
 
  • Like
Reactions: rkshed
I spray wd-40 or liquid wrench into the chain oil res.to mix with oil to make it easier for pump to pick up. also I've used vegetable oil during very cold spells. also keeping saw and oil in side night before helps.
 
I helped a friend buck up a downed oak last winter. He had just purchased a new 445 Husqvarna and I noticed while we were cutting his bar was literally smoking. He shut the saw off and I looked it over. Chain tension seemed right, chain was sharp enough and it spun easily along the bar. We started cutting again and more smoke. I asked him what bar oil he was running and he went to his truck and pulled out winter blend Stihl oil. Apparently the dealer advised he use that oil cause it was "winter". In my area average winter high's are in the 30's and the day we cut was probably in the 40's. I dumped the oil out of his tank, which poured out like water, and refilled with my regular bar oil. The smoking stopped and we continued to cut.

Is there a spec on the blue bottle "winter" oil that discusses temperature ?
 
Is there a spec on the blue bottle "winter" oil that discusses temperature ?
Not on the jug that I have used. What I've started using in cold weather is TSC bar oil . It's a bit thinner than the Stihl and Husq. Bar oil .
 
  • Like
Reactions: TreePointer
I just reg "summer" oil year round. It pours pretty thick in the cold, but the saw warms it up enough it's fine.
 
Is there a spec on the blue bottle "winter" oil that discusses temperature ?


BCA91130-A7FA-44C1-BD84-F3628F95E474-1078-0000018B3F91E2C9.jpg



The "problem" with winter oil is it is thinner. I keep a bottle on hand at all times during the winter for cutting in 0-15-20 degree temps. The biggest thing is to turn down the oil output so it all doesn't fling off.. it is thinner and takes less oil pump output to displace the same amount, so if it is set for regular oil, then it will all fly off, especially in warmer temps.
 
  • Like
Reactions: MasterMech
Nice shot of the blue bottle. Thanks
 
this is old oil. I've had it 4-5 years, so I don't know if the formula has changed over the years or not.....
 
this is old oil. I've had it 4-5 years, so I don't know if the formula has changed over the years or not.....
Mine must be older than that! I bought 4-5 jugs a few years ago .i just went Down to the shop and looked again at the label . It doesn't say anything about temp. , just to use it in cold weather . Weird ! :)
 
Mine must be older than that! I bought 4-5 jugs a few years ago .i just went Down to the shop and looked again at the label . It doesn't say anything about temp. , just to use it in cold weather . Weird ! :)


yeah me too... My amish stihl dealer told me a few years back the price was going up, so I picked up a case of winter and three regular... i'm down to my last bottle of each. I want to say I paid5 or 6 bucks a gallon. its how much now, 10-12 bucks a gallon? TSC had some on sale for 6 bucks a gallon so I picked up a case of that a couple weeks ago.

So how do you like the 562 compared to the 372? i'm thinking about getting one if I can sell my 084 for a decent price...
 
Yeah, at 10 degrees outside I am staying inside. Doubt I would even go hunting when it is 10 degrees outside, much less cutting firewood, when the house is nice and toasty.

I like this post. All my cutting was finished in December when it was mild out. I wouldn't last long at 10 degrees. Cutting is a 30 degree or warmer activity. I do keep my saw and oil indoors though.
 
So how do you like the 562 compared to the 372? i'm thinking about getting one if I can sell my 084 for a decent price...
I love the 562 , it's pretty strong for 60ccs . But I can't compare it to the 372 ,as its been modded. Just going from memory ,the stock 372 had more power,but not as much as you might think .
 
Status
Not open for further replies.