Do I need a new glass gasket?
- Thread starter Dairyman
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
weatherguy
Minister of Fire
Not neccessarily, have you done the dollar bill test on your door? That would tell you if its not tight.
Heatsource
Minister of Fire
Like the above poster said, it looks pretty typical.
the dollar bill test is for the door, not the glass.
for the glass you could do a leak test by getting the fire going and tracing the glass edge w/ smoke to see if there is any room air infiltration
the dollar bill test is for the door, not the glass.
for the glass you could do a leak test by getting the fire going and tracing the glass edge w/ smoke to see if there is any room air infiltration
weatherguy
Minister of Fire
Code:
Like the above poster said, it looks pretty typical.
the dollar bill test is for the door, not the glass.
for the glass you could do a leak test by getting the fire going and tracing the glass edge w/ smoke to see if there is any room air infiltrationAh, you'd be right, I was thinking his door may have been leaking. How often does a glass gakset need to be replaced? I dont recall reading about anyone doing that.
Heatsource
Minister of Fire
basically as needed, if the glass is in contact with steel the possibility of expansion/contraction cracking the glass is much higher
if the glass is loose in the frame thats a good sign it should be replaced[/quote]
if the glass is loose in the frame thats a good sign it should be replaced[/quote]
NH_Wood
Minister of Fire
With the stove cranking right along, I'd use a lighter and hold the flame near that glass / metal frame joint and see if the flame gets sucked in to it. If you are a smoker, you could use the smoke off the cherry of a lit cigarette to check.
I agree with the others that what is seen is probably normal, however, if a flame were to get sucked into that region that would tell you the gasket is not sealed. If it doesn't get drawn in, then you have your answer.
pen
I agree with the others that what is seen is probably normal, however, if a flame were to get sucked into that region that would tell you the gasket is not sealed. If it doesn't get drawn in, then you have your answer.
pen
Ashful
Minister of Fire
Glass gasket leaks usually result in streaking on the glass, in the area adjacent to the leak. Your soot is evenly distributed around the perimiter, so likely not a result of a glass gasket leak.
BrowningBAR
Minister of Fire
tfdchief
Minister of Fire
If I can see the fire and it burns the way I want and think it should, I'm good. It's not a gas stove, there is going to be a little black here and there or it wouldn't look right
What I see is cooling at the edge of the glass, heat taken away by the cast door.
What I see is cooling at the edge of the glass, heat taken away by the cast door.- Status
Similar threads
