Hello,
I am working on building a homemade insert boot so that I can run a full liner for my new insert.
the Ventinox insert boot is too tall for my application.
I have access to a metal fab shop, so building it should be cake, but I have a couple of questions about building this.
1. is 1/8 steel sufficient ?
2. Any recommendations for the type of 6" pipe to weld to the top of it ? I need the size that will connect up with the appliance adaptor for newer stoves.
Any Ideas on the size of what is needed ? OD or ID for 6 " I would hate to weld up the wrong size and then have to adapt to that.
Thank you in advance.
I am working on building a homemade insert boot so that I can run a full liner for my new insert.
the Ventinox insert boot is too tall for my application.
I have access to a metal fab shop, so building it should be cake, but I have a couple of questions about building this.
1. is 1/8 steel sufficient ?
2. Any recommendations for the type of 6" pipe to weld to the top of it ? I need the size that will connect up with the appliance adaptor for newer stoves.
Any Ideas on the size of what is needed ? OD or ID for 6 " I would hate to weld up the wrong size and then have to adapt to that.
Thank you in advance.