Whitfield Profile 30 ignitor

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.
aburress1223

aburress1223

Member
Jan 10, 2011
108
Virginia
I am starting on my fourth winter with a Whitfield Profile 30 and the ignitor failed yesterday, now lighting with hand sanitizer. I ordered one online yesterday and should have it in a few days. Does anyone have any experience or suggestions on replacing these on a Whitfield Profile30?
 
Hi ab think you've figured it out that chaning it will be a pain it will. Did you check the in-line fuse?? Think the Profile has one the adv 2t did... it screws out too and of course time and heat will make it harder. Take the blower(s) out of your way when changing it, good luck.

Stovelark
Enviro EF3 FS pellet
Enviro Empress FPI AC
Enviro Kodiak 1700 FS wood
 
stovelark said:
Hi ab think you've figured it out that chaning it will be a pain it will. Did you check the in-line fuse?? Think the Profile has one the adv 2t did... it screws out too and of course time and heat will make it harder. Take the blower(s) out of your way when changing it, good luck.

Stovelark
Enviro EF3 FS pellet
Enviro Empress FPI AC
Enviro Kodiak 1700 FS wood
Click to expand...
Many thanks, You have confirmed my suspicion that it would probably be a pain. I haven't checked the fuse yet, but I will. Thanks for the suggestions.
 
I put a super igniter in my Whitfield profile 30, worked better than the original. Easy to replace if you have a Crows foot hooked up with a 3/8" swivel
 
smwilliamson said:
No it will not. It does not have a MPNT 5/8 fitting and most likely does not have a 1" cold zone at the pass through connection....it will either burnout premature or fall out and melt wires and such...don't suggest something you haven't tried
Click to expand...
Wow... That sounds snarky! Sorry... I got cut off and then could t remember what thread I was in then had to go.

What I was going to suggest is perhaps you could link to the mpnt which is needed
 
Status
Not open for further replies.

Similar threads

dreamingofpalmtrees
Smoke alarm 4am, house filled with smoke Whitfield Advantage
Replies
1
Views
595
The Pellet Mill - Pellet and Multifuel Stoves
Washed-Up
Washed-Up
N
Harman XXV blows fuse on startup
Replies
9
Views
710
The Pellet Mill - Pellet and Multifuel Stoves
ABusWrench
ABusWrench
R
Harman P68 Ignition Problems
Replies
15
Views
1K
The Pellet Mill - Pellet and Multifuel Stoves
NS P-68
NS P-68
Don2222
Lennox Whitfield Profile 20 Igniters last only a year?
Replies
0
Views
420
The Pellet Mill - Pellet and Multifuel Stoves
Don2222
Don2222
BGStG1aholic
Harman XXV ignitor hardly works and starting via firestarter gel is a bearcat
Replies
9
Views
1K
The Pellet Mill - Pellet and Multifuel Stoves
MarkF48
MarkF48
Top Bottom
Back