New Harmon P35i installed today. Auger not turning

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.

Bjcascone

New Member
Jan 17, 2013
2
Hi
I just installed a new Harmon P35i. Followed instructions installed and turned on and it ignited! ran for 15 - 20 min with no issues. Heated the room up 7 degrees. After 20 min the auger stopped turning and dispensing pellets. I switched it to test and it did not turn still. Any ideas?

Thanks
Brian
 
Proper draft?? Hopper lid switch?? All the wires making good contact?? What lights are on on the circuit board in test mode?? Feed light coming on?
 
Can you describe your exhaust system? Lengths, bends, 3" or 4", etc.
 
tried unplugging the stove? Have you tried using a metal wire hanger into the pellet chute? You may have a jammed pellet.
 
Where is the pictures?
 
Status
Not open for further replies.