Creosote at the top

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.
Nov 7, 2010
168
Southington CT
I often look up at my chimney top when I leave my house and noticed that the wires up there looked thick. When I wen up there is was thick with creosote I bushed a lot of it off at it was causing a back draft with the winds we are having right now. Is this because of the cold snap because this is the worst I've seen it but its the most I have ever burned this year also
 
This is a common occurrence. Even inside the chimney, it is the top couple of feet that get the worst because that is where it is the coldest. When we had a cap with wire, it was a chore we did several times per year cleaning the cap. Not difficult to do with a wire brush but sometimes we'd just stay on the ground and tap the screen with the cleaning poles. Enough would fall off so it would not be a problem. And yes, the cold snap will help this. I will be happy when this is over. Next week!
 
Good I thought I might be doing something wrong I know I'm using less then seasoned wood right not but its what I have because I didn't think my wife would want to use it as much as we are but she is loving it.. No I need to start splitting wood for next year it's been sitting for two.
 
For sure get it split Patrick because in the round all that dries is just a little bit on the ends. That is why those cracks show up. The middle though will still be wet. I've always recommended that folks get 3 years ahead on the wood. Takes care of 99% of all wood stove related problems and you'll also find that you actually burn less wood.

We are into our sixth year with our present stove. After 2 years we cleaned the chimney just to see what and we got about a cup of soot with no creosote. That was the spring of 2009. The chimney had not been touched since. I even took a picture of the interior of the chimney and posted it on this forum. All one can see is a little bit of brown soot. Nice!
 
I had the screen removed from my cap. But, I agree with Dennis, good dry wood would make all the difference in the world.
 
My screen was plugged half way thru the first winter. Started back puffin at the startup. I removed the screen. The next year the cap was again a gooey mess at the end of the year. The pipe was dry. Most of this was caused by burning 1 year old oak. That was 10 years ago. Now that we burn better and burn 5 year old oak the cap gets blackened but stays dry. Never put the screen back on. The only issue is we have gotten a few birds into the stove in the summer.
 
if the screen is the part of the cap that they consider a spark arrestor I would check with you insurance company before removing it. mine required it and i think if something happens they would be able to deny you claim.
 
Status
Not open for further replies.