Euromax from Hell

shorter pellets can cause the stove to over feed from the numbers you posted by 15-25% from the numbers you are posting i dont think the stove is over feeding at all you might want to try a t-stat Enviro when they first launched the M-55 found that the 55k btus that they posted as the out put was actually closer to 70k with the shorter pellets.

the shorter the pellets the more mass that can fit into the auger tube and in turn the more pellets you will feed in an hours time. have you ever tried the t-stat?

ssbn644 said:

Sounds like we have the same board, they can adjust it, if you call them, I have the code to get in for feed rate and burn air, but it really has not made a difference...like I said, last season they said they had a known issue, as for my dealer, when their senior tech came out, they had to call EuroMax as they had no idea on this stove. I get the outside air temp and insulation but when your burning on 1 and 2, there is no way to hit 90 or so, unless it's 50 or 60 outside, but I I was referring to prime heating season, when it's 0 out or in that area, I even closed up the air a bit on the right side of the unit, I was get 6 inch or more flame height on 2, and was told it was only suppose to be 2-3 inches max, sent many pics while on phone with tech suppose, thank god for smart phones, they were getting real time info. a few times on 2 it was nailing the access plate, which is way to high.

Click to expand...

So now I am having problems with my new board.At first I couldnt set the trim rates.Then the auger would stop and the fire would go out.The other night the thing over heated because the blower stopped. So I called the store where I got the new board and they called Tech. for me.Turns out the board needs programed to my stove.No problem just send me the procedure.So they did.Now I am to press the room fan on/off button,feed rate trim button and the combustion trim buttons all at the same time and watch the heat level lights.They should flash on and off to tell you which program the stove is set to.All it did was flash all 5 lights on the heat indicator panel.I am to repeat this until the lights flash 4 times for the program I want. Wont do any thing but flash all lights all the time when holding buttons down.So I called again and they suggest a service call.No problem I said but if the board is bad I am not paying for the service call.Let me talk to a Tech. and we can figure out if I am doing something wrong or if the board is bad.This way we dont waste a bunch of time.I will have to call you back is the answer I got.So now I wait.If you have programed your board did you run into this problem or I am doing some thing wrong.I dont know if there are any Tech. guys on here that can may help as well.