breckwell p28 fs

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.

mtalea

Feeling the Heat
Dec 14, 2005
350
Bristol, Connecticut
last year and this year I have experience an issue when switching speeds of feed and fan knob where the unit will continually feed pellets without stopping....I have to switch back and forth on the speed rate til it stops. what will cause this?
 
OK ppl I changed my air switch.that did nothing to fix the auger doing a constant feed unless i play back n fourth with the speed knob till it works right....anyone have a solid idea on this?
 
Are those knobs connected to switches?

If so the switch is dirty or the contacts are not positioning the same as they were when new or they are worn and not making proper contact to reliably pass current.

If those knobs are connected to pots (variable resistors) then the wiper is dirty or no longer making proper contact with the material that provides the resistance.

Sometimes contact cleaner will take care of the problem. If that doesn't work then what the knobs are connected to needs replacement.
 
Are those knobs connected to switches?

If so the switch is dirty or the contacts are not positioning the same as they were when new or they are worn and not making proper contact to reliably pass current.

If those knobs are connected to pots (variable resistors) then the wiper is dirty or no longer making proper contact with the material that provides the resistance.

Sometimes contact cleaner will take care of the problem. If that doesn't work then what the knobs are connected to needs replacement.


Its just 1 knob you turn to select A B C D E F speed...D is normal startup mode. after the fire is going I switch it to C for a comfortable temp and speed but once you switch it to C it will feed pellets and not stop unless you go back and forth till it finally works right..ie run for say 3 seconds stop for 10 secs. repeat.
 
A rotary switch is prone to contact oxidation, dirt build up, and contact loosening.

Get a can of electrical contact cleaner from a place like grainger or handy dandy tandy (radio shack).

It was also known as tuner cleaner in prior eons. A spray of that and a working of the swtich trough all positions several times and then let it dry just might do the job otherwise install a new switch. .
 
A rotary switch is prone to contact oxidation, dirt build up, and contact loosening.

Get a can of electrical contact cleaner from a place like grainger or handy dandy tandy (radio shack).

It was also known as tuner cleaner in prior eons. A spray of that and a working of the swtich trough all positions several times and then let it dry just might do the job otherwise install a new switch. .



thanks I will try that. I just wasnt sure if it was the switch or something else like snap discs or other changable parts
 
Status
Not open for further replies.