I bought a magnum baby countryside used, the man said the auger would not work so I got it cheap. I made sure the jumper was set on the 1 and 2 pin on the board. I can see the auger spinning but sometimes it drops pellets and sometimes it dont, I primed the auger the way the manual says, waited sometimes a hour but the fire almost goes out. I took the auger out and checked the shoot, theres nothing in there. The auger light comes on for 3 seconds at the longest and stays off for about 7 seconds, sometimes it drops pellets sometimes it wont drop pellets until the flame almost goes out. I have cleaned everything I could, if I hold the auger button down it will build up enough pellets to get a good flame. Im not sure if it has the correct auger in it, does anyone have a picture of what the auger should look like?should the auger motor be 2 RPM? mine is and its pulling .4 amps, the rating is .59 amps