Anyone have trouble on a ep25 with the pellets not sliding down the walls to the auger. They just tunnel down the middle and then the fire goes out. The pellets around the outside never cave in.
pellets don't empty hopper
- Thread starter donpfff
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
P38X2
Minister of Fire
Try polishing the inside of your hopper a bit with 0000 steel wool. Vacuum out the dust afterwards.
briansol
Minister of Fire
Common problem. Smooth it up like above. Avoid using flammable oils as lubes. Me, I keep a big spoon near by and move them in between fillups.
Same problem on my Whitfield. I cleaned with fine Scotchbrite and then waxed with auto wax. Helped quite a bit, plus I knock down any remaining lumps before I refill.
SNAPMAN61
Member
I am fortunate not to experianced that yet, and I am not familar with the ep25. I have seen a tech guy buffing down the seams with a air grinder at a store once to solve that priblem. not sure as to how well that worked, but he had it pretty smooth.
x2 on what snapman61 said
x2 on what snapman61 said
drewmo
Feeling the Heat
P38X2
Minister of Fire
Use foil tape on the seams if that's the issue. Keep it FLAT and wipe the area down with alcohol first to ensure proper adhesion. No, not tequila.
slvrblkk
Minister of Fire
If the inside has some paint on it, it's best to remove the paint down to the metal. You need to get it as smooth as possible. I rub wax paper on it once in a while and it's good to go for a while. By design though, you will never get all the pellets to feed all the way down....it's just the nature of these beasts.
- Status
Similar threads
