This is my first burn season and i'm noticing when I clean the stove that some areas look "wet". Especially in the burn pot below some of the ash that remains. The aggitator is usually dark brown and seems moist too. And the sides of my burn pot tend to aggregate ash in clumps. Not hard clumps though -with the slightest tough or vibration they collapse.
Additionally, my burn pot seems to be corroding or rusting. I always have to spend at least 10 mins scrapping off clinkers with each cleaning too.
I recently adjusted my air inflow so that the flame is bright yellow, almost white and brisk. I feel it's at a good place, but what could be causing this? Should i be concerned?
Using Green Supreme again (I used 10 bags of Hearthside recently too) and have a GCI60 insert. Our pellets are stored in the garage and have not seen rain or snow since we received them.
Thanks for any suggestions.
Additionally, my burn pot seems to be corroding or rusting. I always have to spend at least 10 mins scrapping off clinkers with each cleaning too.
I recently adjusted my air inflow so that the flame is bright yellow, almost white and brisk. I feel it's at a good place, but what could be causing this? Should i be concerned?
Using Green Supreme again (I used 10 bags of Hearthside recently too) and have a GCI60 insert. Our pellets are stored in the garage and have not seen rain or snow since we received them.
Thanks for any suggestions.
