The status light was originally blinking 3 times. Bought a new esp probe and installed that no problem. Had feed rate turned up high and the flame kept getting lower. The stove wasn't feeding pellets. Finally just turned it off. We are headed for cold here in MA. Any thoughts?
harman pp38 not feeding pellets
- Thread starter rhschumaker
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
Hoot23
Minister of Fire
Auger jam or auger motor crapped out. Are pellets bridged in the hopper? Slide plate functioning?
Bioburner
Moderator
Fines box clean? Try check to see if auger is feeding properly when in test mode. Done the dollar bill test on door gaskets lately?
door gasket is going - can tell by the soot deposit on the glass. fines box was filthy and packed. slide plate fine and pellets normal in the hopper.
Bioburner
Moderator
Did you put the stove into test mode and see if getting a good pellet feed? I had once something in the auger flights that caused a meager amount pellets to feed. If the gaskets are going, you may get them by for a short time by carefully squeezing them with a pliers to bulk them up till you get them replaced. Intermittent feed can be because of vacuum switch not keeping the feed circuit happy as the stove warms and the door expands etc
- Status
Similar threads
