I have a bad thermocouple and would like to replace the whole pilot assembly in my fireplace. I've done this before on another Mendota fireplace and it was straightforward. There is so little working room, I can't figure out how to detach and remove the burners to gain access. If anyone has experience with this unit I'd appreciate any tips. Attached is a picture of where I'm at.
Replacing Pilot Assembly - Mendota Chelsea M27
- Thread starter GrassFed
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
Looking at the pic, I'd say if you remove the 4 zipscrews that hold the burner brackets to the floor, the burner tubes will slide right off the burner orifices. I've encountered this type of burner mounting on other units, & it's pretty common...
Last edited:
Thanks for the feedback. I recall them sliding out of my other fireplace. This one they seemed to be screwed on, but it's hard to get a look underneath the sheet metal. I'll give that a go and will report back. Appreciate the help.
Heatsource
Minister of Fire
interesting pilot configuration, looks like the t-pile is between the pilot and the main burner...
- Status
