Ok, so im new to the pellet stove world. We just bought a used stove, it starts up feeding pellets good and has a high flame putting out good heat.after a little while the heat will turn to warm n stay between worm n cool never goes back to hot air blowing out. Flame fluctuates high low, pellets dont come out as fast as whem it first startes. Ive tested the auger motors they work, all the rubber vacuum hoses look to be new the previous owner replaced gaskets around door n glass. Any suggestions would be greatly appreciated
Summer heat 25-pdve not putting out much heat
- Thread starter gbaxter088
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
I have them at 8-8 right now. I just put a different type pellet in and its in start up at the moment the blower hasn't even kicked on yet
So its done with start up mode. As soon as the start up mode is done flame goes down and pellets slow down. Pellets dont come out any faster on 9 then on 1
8-8 should be throwing out some serious heat. What are the bottom 3 buttons set at and what year was the stove made? You can check the hopper lid for the date it was made.
slvrblkk
Minister of Fire
You could try opening the feed gate at the bottom of the hopper a bit more....provided that there is one there.
slvrblkk
Minister of Fire
As Swine said...if the wire isn't there, it will go into low burn if you aren't using a thermostat.
I had a feeling it would have something to do with thermostat i looked to see if tgere was a manual/ auto switch. So the wire would help then ill try tgat. The feed gate is fully opened
- Status
Similar threads
