Our auger motor died this morning and I'm starting to replace it. Here are the steps I was given from a previous thread:
Make sure you have all the pellets out of the hopper
Disconnect wires from terminal board
Lossen and remove the allen head screws at the base of the auger "tube"(these will be metric).
Pull entire auger and motor out of stove
Vacuum well
reinstall
Is there anything else I need to think about? Do I need to lubricate anything before I install the new motor? If so, what type of lubricant and where is it applied? Thanks guys.
Make sure you have all the pellets out of the hopper
Disconnect wires from terminal board
Lossen and remove the allen head screws at the base of the auger "tube"(these will be metric).
Pull entire auger and motor out of stove
Vacuum well
reinstall
Is there anything else I need to think about? Do I need to lubricate anything before I install the new motor? If so, what type of lubricant and where is it applied? Thanks guys.