quad castille no feed no power to ignitor

I bypassed vaccum switch,snap disc #2.I cleand out hopper and auger.The thermocouple seems to have continuity. I blew out vaccum hose.Don't tell me it could be an auger motor,I already changed 1 out on my MT AE this week.Exhaust blower comes on.

I'm kinda leaning toward thermocouple,cause when I manually start it convection blower kicks on when it gets hot enough.Now I'm thinking auger motor.

No not yet will do now,4 blue lights blink

Ignitor has continuity,but no power to it.Seems if thermocouple was shot the convection blower wouldn't kick on.

with power on ,no juice to ignitor

Going to dealer tommorrow with control board,and they can test it, or put it in one of their stoves and see what it does.The date on the control box is12/08 and this stove is supposedly 3yrs old so.If it's junk then I bet I get 1 for nothing seeing I only put 12 bags through it.I know I bought it used 2 weeks ago,but I spend a lot of $$$ with these people,as I've bought 3 stoves and a hottub from them.

gonna change out ignitor first,my question is will it take the same ignitor as the MT vernon ,asI have 2 spares?

Ignitor checked out good,hooked it up to MV and it worked.Control box on the other hand smells burnt inside,so I would believe that is the culprit.

Cotrol box is good

I put in new thermocouple,one I took out had a bare spot on wire where it exits the firebox.Another thing was a communication issue with the thermostat and receiver.I also didn't know you had to prime the auger by pressing the reset button a bunch of times.So I'm back up and running again. thanks for the responses.

Well still had an issue,everytime stove wanted to startup I would have to hit reset button.I put a new vac switch in and wallah it's finally runn right.