Did I mess up?

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.
I tried for the first time yesterday to split some 3 year old rounds of black ash and even a 20 inch long 8 inch round laughed at my X27. I just read through this thread https://www.hearth.com/talk/threads/split-now-or-in-spring.136250/ and it sounds like people process wood soon after it is cut. I am starting to think that by letting my ash dry I have just made more work for myself. When I did manage to get a split off with some wedges it is testing at 16 to 20% moisture. BTW I had to drive the wedges separately to keep from getting them stuck. In an 8 inch round it was drive a wedge out of sight along an edge then use a second wedge from the side of the round to finish the split and free both wedges. No way it should be this hard.

Don't know much about ash but all the wood I process is split the day it's dropped.
Once the ends get weathered splitting gets tougher.
I like to split from the bottom of the tree up. Less chance of trying to split a knot. I also
try to hit the middle of the round with the first strike. Oh yea the colder the better.
Everything gets piled and covered close to where it's dropped. Makes for less handling
of wet ( heavy) wood.
BTW check moisture after its been indoors (warm) then re-split. Cold wood will give you a false reading.
 
You are always going to have tough pieces of wood, personally if I couldn't burn the 20" piece as is I would put it in my saw buck and make 2- 10" pieces out of it .I bet the fiskers would have no problem then.
 
Status
Not open for further replies.