Fireview: How low setting ?

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.

Lakeside

Minister of Fire
Feb 6, 2009
605
Mike's World
Hi,

How are you all doing ? My question: How low an air setting are Woodstock fireview owners using this time of the year ?

My set-up is a 22 foot chimney (exterior wall) with an isolated stainless liner. I am running the stove with it set around 3/4 without back buffing with outside temps avg. in the teens. The temps this weekend should be lower near zero.

So how low a setting are you all using for similar conditions and zero outside temps?

Thanks of your input.
 
I'm running mine at about .5-.6 and the stove top is cruising at 550. I'm burning a mix of ash and apple with moisture content of 16% on the apple and 18% on the ash. The outside temp right now is 22*.
 
I seem to cruise well around .75 but as it is warmer outside today (about 40) she is all tucked in for bed at .5 right now. I should get 8+ hours before it comes all the way back close to 250 for a reload on 5 splits of 12-14% junk elm and cottonwood.
 
I am running the stove with it set around 3/4
Just checking, but you're saying .75 out of a possible 4, not with lever 3/4 open, right? I was running the Fireview on a 16' stack (6" SS with tee.) It was plenty of stove for the space, so a lot of times I'd run with about .3 air or less, even if lows were in upper 20s. Stove seldom acted like it wanted to back-puff...
 
"you're saying .75 out of a possible 4, not with lever 3/4 open, right?" Yes

I had a few back buffs in the past so I maybe a little gun shy of going to the lower settings.

My reloading method is add some splits, let them fire / char for about 10 minutes, then drop the air down to 1 or less.
It seems that I get back buffs if I drop the air down to soon with warm outside temps.

I would like to reduce the risk of back buffs and also set it low. Any thoughts on my reload method ?
 
Thanks everyone for the replies. I took a second look at Woodstock's site and found there cures for back buffing . This has a few points that helped me ,
Here it is for those of you interested. Good burning to all.
 

Attachments

  • Cures For Backpuffing.pdf
    412.3 KB · Views: 543
My reloading method is add some splits, let them fire / char for about 10 minutes, then drop the air down to 1 or less.
It seems that I get back buffs if I drop the air down to soon with warm outside temps.
Sounds good. I might cut the air in a couple stages, myself, so when I got to 1 or so, temps would be ready to close the bypass. Then after the cat got going I might try to cut it further in small imcrements, depending on where I wanted to cruise it. When would it back-puff, before or after you closed the bypass?
 
Last edited:
  • Like
Reactions: ddddddden
When would it back-puff, before or after you closed the bypass?
After closing the bypass is when I had most of my back buffs. Usually after to aggressive an air reduction with fresh splits. Patience is a good thing to have with wood stoves.

I think my lowest setting is 1/2 on a zero temp night.
 
Status
Not open for further replies.