Can anyone tell me if I can scoot a princess out onto a raised hearth as far as my flue allows. My current flex liner and block off plate for my nc30 are set up to allow the nc30 stick out as far as possible onto hearth. As long as the princess inserts shape is square im sure the pipe / surround for the insert should cover everything properly? Thanks
bk princess insert shape
- Thread starter tjcole50
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
For some reason I was thinking the rear if the princess was tapered to the rear getting narrower. So if it were to be brought out onto the hearth further then the surround wouldnt fill the gaps on the side of the stove. If it is a conpletely square design I dont see an issue. Hard to describe I guess. Just trying to get it to stick out as fsr as possible I to room
weatherguy
Minister of Fire
mellow
Resident Stove Connoisseur
Check out the manual, that should help you out: http://www.blazeking.com/PDF/manuals/en/wood/OM-PI1010A E V1.09.pdf
- Status
Similar threads
