Husky 142E muffler mod???

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.
I have to replace the muffler on my 142E chainsaw.
Should I modify it before I install it?
What would I do to modify it?
Just thought I would ask.
Sean
 
If it is aftermarket the inside maybe empty and then you just have to open up the hole a little bit.

If it has stuff inside pray the halves apart and get rid of a good chunk of the baffles then open up the hole a little bit.

Reassemble,
put back together,
Run for a few minutes,
Adjust carb
ENJOY
 
What is the benefit of removing the baffles?
 
Less restriction

You don't have to completely gut it out just reduce the restriction a bit.
The aftermarket mufflers don't usually have all the EPA crap inside so they breathe a little bit better.
Don't forget to retune so you don't run it too lean.
 
If it has stuff inside pray the halves apart and get rid of a good chunk of the baffles then open up the hole a little bit.
I have a stock replacement muffler..It seams like I would ruin it by prying it open.
Is there a trick to opening it up?
And what hole are you referring to???
 
It is a royal pain to pry it apart with a thin screwdriver but its easy to crimp it closed. If you are good at welding/brazing thin metal you can cut it open then close it back up that way.

The hole is covered by the spark arrestor.
 
Status
Not open for further replies.