Inside my pole barn the concrete floor always feels damp. When we poured the floor years ago poured it over gravel. Someone said to me that I should have put a vapor barrier down like a sheet of plastic then poured over top of that. Well it's too late and I am in the process of making a little office inside my building and I don't want to have moisture issues in that room. What are some of my options? Thank you Anthony
Moisture on my pole barn concrete floor
- Thread starter adamant118
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
Dr.Faustus
Minister of Fire
You have to first determine if the damp is from water wicking up from the ground, or condensation from moist air hitting the concrete. I believe you do this by taking a piece of plastic and taping it to a small section of the floor. say 12"x12". then wait a few days and pull up the plastic. If its wet then the moisture came from underneath. if its dry then the problem is condensation.
Highbeam
Minister of Fire
Yes, gravel below and then plastic and 2" of foam on bottom and sides of slab.
Cold slabs feel wet. Tape plastic down as described above to test.
Then just plan on a bare concrete floor. Office furniture and finish materials not moisture sensitive and don't put boxes or stuff on the floor.
http://www.homedepot.com/p/DRIcore-...core-Subfloor-Panel-CDGNUS750024024/202268752
There are a few similar products to this but it will solve your problem cheaply for an area like an office.
There are a few similar products to this but it will solve your problem cheaply for an area like an office.
Ok.. so if I have moisture under the plastic text sheet I have to put down the dricore but is not then what?
Highbeam
Minister of Fire
If you have a lot of humidity in the air and a cold slab, the water will condense on the slab. If the slab doesn't have perimeter insulation, cold temps on the outside will pull a lot of heat out of the slab keeping it fairly cold especially near the outer walls of the building. Add in a source of humidity in the air, like washing a car or just parking a snow covered car or truck in the building and using hot air heating, including a wood stove will tend to put a lot of water vapor in the air which will condense on the cold slab. This will be more noticeable in a "tight" building then a typical garage as a typical garage will be pulling in a lot of dry air so the humidity will not get as high.
- Status
Similar threads
