Drolet ECO 65 with a Crosslink conversion kit

As promised here's my install of the Crosslink kit on an Eco-65.
Looking at the picture, return is on the right and Hot on the left.

Running at setting 3 on the pellet stove and my fan running constantly
which has the effect of cooling the water constantly i'm getting 110F out and return at 90 which proves me
that my taco pump running in Delta mode is doing it's job.

I powered off my furnace fan and the water got up to 140F, then I turned on my fan
and the temperature at the register was showing 100F compare to 80F when I'm on the heat pump.

An aquastat is in the mail so that I will turn the fan On at 130F and off probably at 120F and
see how I'm doing.

when I was running the fan constantly with a 110F OUT the entire house was more balance in heat
than when I ran the pellet Only and the Fan ON.

I'm convinced that I can keep the house warm entirely but will continue to experiment for the best solution ..

hyfire said:

Wow , looking good whats the white box beside the furnace , looks like a water heater?

Click to expand...

Hey Hey Hyfire, long time no see. It is a water heater but not connected, I'm using it has the holding tank.

Running this on 3 and in pilot mode and stove will go off, meaning that it was running on pilot for 45 minutes.
Good but I'm putting more wear on igniter than before...which brin me to this question.

Do you know if the pilot time can be adjusted other than the default 45 minutes?????

hyfire said:

Its actually 30 minutes I timed it and as far as I know it can;t be adjusted. How efficient is your new setup?

Click to expand...

Hummm 30 minutes so the manual is wrong.. I can keep the entire house very comfortable now.

Bioburner said:

So Tommy got a crosslink into Canada
I like the way mine is working. No aquastat needed. return of 70 out at 110+-. Pump on medium speed

Click to expand...

If you don't mind me asking, what type of system do you have????

Set on 3 return is 95 and out is 123, trying to keep pump at lowest speed (6.8Gals).
I'm using a water to air Echanger and keeping my HVAC fan on constantly that keeps
entire house (2600ft) at 73F

hyfire said:

How much did the conversion cost in total in Can $?????????????????????

Click to expand...

I'd have to search for all the bill, I'd say around $2500

maple1 said:

Getting a bigger shaft on the currency exchange prices....

Click to expand...

Yep on the currency but fortunately got all my stuff early last year....Oufffffffffff.

Different situation here Propane is at $2.11 and Cubex pellets are $300/ton....

maple1 said:

BTW where did you get the stainless piping in the pics? Or was it part of the kit?

Click to expand...

Yes that was part of the kit..

hyfire said:

ANy updates how much are you saving $$$$$$$$$$?

Click to expand...

Not sure we are saving in burning pellets this year compare to cheap LP.
probably not taking that much less in pellets but much more comfy in the entire house..