Cab50 not feeding
- Thread starter sarahandr
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
Hdhogger
Feeling the Heat
Call light on. No fire.
Unburned pellets in
firepot.
Firepot is dirty.
Igniter chamber blocked.
Igniter not working.
Control box defective.
Firepot floor open.
Clean firepot. Make sure there is not a
clinker in the firepot. Clinkers may have to
be pushed out of firepot with firepot cleanout
tool or other means.
Clear igniter chamber using firepot cleanout
tool.
Remove ash drawer to see if igniter is
glowing red on start-up.
Check igniter wires for good connection.
Use a multimeter to check igniter for continuity.
Replace igniter using instructions in
manual.
Replace control box.
Slow or smoky start-up. Firepot is dirty.
Igniter chamber blocked.
Firepot floor partially open.
Excessive amount of fuel at start-up.
Clean firepot. Make sure there is not a
clinker in the firepot. Clinkers may have to
pushed out of firepot with firepot clean-out
tool or other means. Check if firepot floor is
closed all the way
Reduce feed rate using feed rate adjustment
control rod located inside hopper.
Close firepot floor.
Clear igniter chamber using firepot cleanout
tool.
42
Unburned pellets in
firepot.
Firepot is dirty.
Igniter chamber blocked.
Igniter not working.
Control box defective.
Firepot floor open.
Clean firepot. Make sure there is not a
clinker in the firepot. Clinkers may have to
be pushed out of firepot with firepot cleanout
tool or other means.
Clear igniter chamber using firepot cleanout
tool.
Remove ash drawer to see if igniter is
glowing red on start-up.
Check igniter wires for good connection.
Use a multimeter to check igniter for continuity.
Replace igniter using instructions in
manual.
Replace control box.
Slow or smoky start-up. Firepot is dirty.
Igniter chamber blocked.
Firepot floor partially open.
Excessive amount of fuel at start-up.
Clean firepot. Make sure there is not a
clinker in the firepot. Clinkers may have to
pushed out of firepot with firepot clean-out
tool or other means. Check if firepot floor is
closed all the way
Reduce feed rate using feed rate adjustment
control rod located inside hopper.
Close firepot floor.
Clear igniter chamber using firepot cleanout
tool.
42
The light that flashes blue when you first plug it in and turns green once the stove is running, that's what was flashing orange. The call light was still red. Anyway, it seems to be working now. I emptied the hopper and cleaned the auger. Pressed the reset button and so far so good. Thinking there was a jam and it quit feeding and therefore shutdown. Hadn't cleaned the hopper in a while.
- Status
Similar threads
