Huskee 22 ton log splitter not working

I have a Huskee Model 21-53613 22 ton log splitter purchased a few years ago at Tractor Supply. Never had a log splitter before. I've split maybe ten cord so far, and it's been working fine up to now. I fired it up the other day. Even though the motor was working perfectly, when I went to split the first log, nothing happened when I pulled the handle to lower the wedge. There doesn't appear to be any fluid leaks. What should I be looking at to diagnose the problem and repair the splitter? I'd appreciate any suggestions as I've never worked on one before.

I couldn't find much information on log splitter repair on the Internet, so could really use your help and suggestions. Thanks.

Mike

I'll take a look in the morning. Thanks

Thanks again Jags and pen. I'll figure out what and where the lovejoy is and see if its got a sheared pin too. Appreciate you help.

Mike

Thanks for the picture and further information Jags and blades. I checked the hydraulic fluid as suggested. It reads just below the "needs oil" line on the dipstick. I went and purchased a couple of gallons of fluid at Tractor Supply this evening. Hopefully when I add some tomorrow everything will work perfectly. If not, checking the lovejoy is up next.

Admire you making your own splitter Jags. Read your linked thread. Impressive to say the least. Thanks again.

Mike

Did your really split that massive hunk of wood in your picture with your splitter? It looks monstrous.

Turned out to be the lovejoy. Couldn't see it the way the Huskee is built. It's located behind a metal frame under the motor. Had to order both halves and the spider too. Should be in Thursday and its splittin' time again. Hopefully this warm spell will last past then. Thanks for your help.

Mike