Wood drying update in my pile.

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.

Rockey

Minister of Fire
Dec 18, 2007
811
SW Ohio
Ok, I got a new Extech moisture meter that will promptly go back on Monday because it was advertised falsely. Grainger has it listed as reading from 0-100%. It specifically states in the manual that it does not measure mc in percentage, rather it is a relative measurement with an approximate conversion scale you can use. I really wanted to get a pinless type but they didn't have any in stock and I was very impulsive this afternoon.

Anyway, the meter is good for a relative and repeatable comparison so what I did was measure a piece of kiln dried cherry lumber that has been in my basement for over a year. It measures a 1. I split a piece of red oak that threw a bucket of water out when it sp-lit, it measures 110.

Here is what my woodpile measures: Standing dead ash that had no bark on it anywhere, c&s;2 months ago measures a 1. Standing dead locust with no bark, c&s;1 month ago measures 22. C&S;cherry that was green 2 months ago measures 28. Green Hackberry that was c&s;1.5 months ago measures about 45. Green Oak c&s;2 months ago measure s 70. Green Mulberry that was c&s;1.5 months ago measures 90.

I really wanted to burn the Mulberry this year, but I don't think its going to happen. I won't get into the oak until sometime in Jan. I have lots of seasoned Ash, Sweetgum, and Locust to hold me over. I have about 17 cords in the backyard and soon should be 2 years ahead.
 
Rockey,

I know what model you are talking about, there is another one, the M210 that measures in percent and I have found it to be accurate enough in the sense that >25% reading won't burn well.

Dang, 17 cords would probably put me at least 5 years ahead.
 
Jimmy,

I looked a that one too, but it wasn't in stock.
 
Rockey said:
I have about 17 cords in the backyard and soon should be 2 years ahead.

Ya really should try closing the door on that stove sometime. :coolsmirk:
 
They make doors for 55 gallon drums? Whats next, a chimbly for it too.
 
17 cords and not yet 2 years ahead!!!! How much are you heating and with what? That would be a huge amount of wood to cut each year for sure. btw, we have around 21 cords and are set for about 7 years.
 
Backwoods Savage said:
17 cords and not yet 2 years ahead!!!! How much are you heating and with what? That would be a huge amount of wood to cut each year for sure. btw, we have around 21 cords and are set for about 7 years.

Heating 2700 Sq ft with a Energy King Insert. I dont know the firebox size but I'd guess about 2.7- 3.0 . Even burning 24/7 It doesn't keep up when it drops below 20 deg. This year I will be insulating the basement and installing an Englander 30 that I recently bought in the basement. With both going I should be able to go without propane but I expect to burn between 8-10 cords. I really won't know for sure until the heating season is over.
 
Extech M0220 reads in % so I don't have to think...which I really like. 17 cords would get me through ~2 1/2 years...but I'm talking softwoods burning two stoves in different buildings...if I could get the kind of wood you burn, it'd last me longer, I'm sure. Gotta go check my chimblies now. Rick
 
Status
Not open for further replies.