I was checking out my stove and wondering if there's any reason why I can't make replacement secondary tubes myself? I believe they are stainless, right?
Secondary Burn Tubes
- Thread starter JMF1
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
stoveguy2esw
Minister of Fire
JMF1 said:
the diameter of the holes, spacing and angle of the holes must be correct or the unit will likley not burn as it should. i'd be hesitant to do it unless i had the means to do it exactly to manufacturer's specs
madrone
Minister of Fire
call me crazy, but I'd do it. Matching up hole placement and size shouldn't be too tough. If you have a chop saw and a drill press it seems very doable. My question would be which alloy and wall thicknesses would be acceptable. If I ever need to replace tubes I'll probably give it a shot.
DeePee
Member
While reviewing specifications on various insert options I noticed that on some units the size and pitch of the holes varied per burn tube.
DP
DP
jebatty
Minister of Fire
I would try almost anything, unless the mfr provides the needed part at a very reasonable price.
My stove is 18 years old, has a channel iron-like secondary air inlet at the top with the drilled holes, and below that is a 4" x 1/4" steel bar which superheats to aid in secondary combustion and keep the high heat away from the secondary air inlet itself. When the steel bar first burned out, I tried to get a replacement from the mfr, thinking it was something special. No mfr response. So now about every 2-5 years I simply buy steel stock, cut it to fit, and replace it. I use stainless screws to attach it to the channel iron secondary air inlet. Been doing this for 10 years. Stove works great.
My stove is 18 years old, has a channel iron-like secondary air inlet at the top with the drilled holes, and below that is a 4" x 1/4" steel bar which superheats to aid in secondary combustion and keep the high heat away from the secondary air inlet itself. When the steel bar first burned out, I tried to get a replacement from the mfr, thinking it was something special. No mfr response. So now about every 2-5 years I simply buy steel stock, cut it to fit, and replace it. I use stainless screws to attach it to the channel iron secondary air inlet. Been doing this for 10 years. Stove works great.
- Status
Similar threads
