ok I did the following:
shut it down then follow this procedure to “reboot” the control board;
1. unplug
2. plug in, then immediately press all 3 bottom buttons together and release
3. you will see an “F-S” in your readout , then a 1-1
4. unplug the stove again when the 1-1 appears
5. plug it in again , and immediately press the blower speed up and blower speed down arrows together and release, you will se an “A” in your heat range , very quickly push the heat range up arrow until it reads “d” then turn the unit on, see if it goes back to running normally.
Put when I did step step 2, step 3 never happened? When I did step 5 that worked fine?
Why I started this is because Heat Range is stuck on setting 1 and Blower Setting is stuck on 9.
Mike if it helps this unit was built 9/01.
shut it down then follow this procedure to “reboot” the control board;
1. unplug
2. plug in, then immediately press all 3 bottom buttons together and release
3. you will see an “F-S” in your readout , then a 1-1
4. unplug the stove again when the 1-1 appears
5. plug it in again , and immediately press the blower speed up and blower speed down arrows together and release, you will se an “A” in your heat range , very quickly push the heat range up arrow until it reads “d” then turn the unit on, see if it goes back to running normally.
Put when I did step step 2, step 3 never happened? When I did step 5 that worked fine?
Why I started this is because Heat Range is stuck on setting 1 and Blower Setting is stuck on 9.
Mike if it helps this unit was built 9/01.
