Whitfield profile-20 circuit board
- Thread starter fwijr
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
Revig
Member
Hi fw,
Not sure I understand your question, are you talking about the Profile 20 control board? If so,what version? The Pro 20 CB has the on/off, heat output and blower output touch pad on the face of it. On the bottom of the board, behind the little fold down door are the fine tune calibrations. I'm not aware of any "dip switches" .
Not sure I understand your question, are you talking about the Profile 20 control board? If so,what version? The Pro 20 CB has the on/off, heat output and blower output touch pad on the face of it. On the bottom of the board, behind the little fold down door are the fine tune calibrations. I'm not aware of any "dip switches" .
The dip switches are located on the circuit board, visiable by removing the back plastic cover on circuit board inclosure. They are marked 1,2,3,4, and are the size of an IC. The circuit board is made by Index Sensors Controls Inc. (Profile 20 Ver. 1.13)
Revig
Member
Hello FW,
Just wondering why you need to know about those. That is sealed off for a reason and shouldn't be messed with. Are you having troubles or just curious?
Just wondering why you need to know about those. That is sealed off for a reason and shouldn't be messed with. Are you having troubles or just curious?
Both, I have the augar feed at max with the adjustments in back of the small door at the bottom of the control pannel. I suspect the pellet size required the adjustment change. The stove runs ok at this setting. Before I made the adjustment the pellet feed was erratic and fire would come close to going out because of lack of pellets. I know the augar motor is feeding, I had a volt meter across the motor and it's getting steady pulses, the shaft is also rotating with each pulse.
- Status
Similar threads
