how long do you have to let a log ( not board ) dry before you can paint or stain it? Prob about 10 to 12 inch by 6 feet. Do you have to let it dry at all?
how long to dry logs before they can be painted or stained?
- Thread starter efoyt
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
smokinj
Minister of Fire
John the Painter
Member
I would let it dry very well before painting or staining.The dryer the wood the better the stain will penetrate.I would suggest stain over paint as it will fade instead of peel and chip. Good Luck.
i'm going to make a wine rack out of some. stand up strait, some sort of base, don't know what yet. Then drill wine bottle sized holes thorught the log. I would rather not have to let the logs sit in my garage for a year before i do it. I will prob do ash or maple. I also have some cherry i could use but i think that would be a pain to get the bark off of. I bet i wouldn't have to let the ash dry for long. can you stain wood right away?
I think the cherry would be the best. Looks the best, dries very fast. If you let it season the bark will fall off. Cherry however usually has some infestation that comes with it in my experience. I would let any of them dry for at least a year without the bark on (in doors) off the ground.
There were some at my dump two weeks ago before i had this idea but i think someone got them. I think that is the only time i have seen timber framed barn beam's laying around. i'm going to go back and check this weekend but I'm almost sure that they were not there the last weekend.
but i could prob go another 20 years without seeing those laying around. can't believe i didnt' grab them
but i could prob go another 20 years without seeing those laying around. can't believe i didnt' grab them
Cutting your "holes" or rack design in the log should help it dry much faster! Any type of paint will blister/peel as the moisture in the log weeps out. stain needs to be absorbed, hard to get stain to soak in when water is still trying to get out.
devinsdad
Member
They recommend that a new deck 'weather' for that same reason before finishing. all that wet wood needs to dry out before staining or painting.If painting 'green wood' it might trap alot of moisture inside and not cure properly?
How about not painting or staining - if i take the bark off and bring them inside is their a downside to not staining? bugs ect ect?
all set with that, worst case i will cut some cherry ash or maple that is on my or my famailys land and let it age for a year. hopeing the old timber framed ( beams) are still at the dump.
bbeals
Member
If your building a rack for the aging or storing of wine, one year seems like a small amount of time for your rack to season. Our wind typically comes out of the case and then in the glass, storage is not necessary around here. :cheese:
- Status
Similar threads
