Dead Leaner
- Thread starter thewoodlands
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
Normally a leaner like that I cut from the bottom up and just let it keep on dropping down until it falls. If it gets too upright on you just lift it up and out until it leans some more.
Gary
Gary
Gary_602z said:
Gary the one on the right was supported by the leaner on the left so I winched down one and both fell plus it's safer winching it down.
zap
zapny said:
Probably safer but that is the way my wife tells me to do it,right after she looks at my life insurance policy! :lol:
Gary
golfandwoodnut
Minister of Fire
zap, I always split the wood before I give it a moisture test. I do not figure the outside is any real indicator. Even if I have split wood, I split it again.
GolfandWoodNut said:
Because the rounds are small I decide to check the m/c unsplit then next Sunday split the rounds and check again. I should have mention this in my post.
zap
ash burn
Member
ash burn said:
ash burn I'll split it on Sunday after drying down cellar by the wood stove then take a reading. I'm thinking we should drop 7 to 9 percent on each round.
zap
- Status
