Nine year old Harman Advance Pellet stove buriing Pellets.
Starts fine, Flame is sharp and crisp, stove is hot.
Stove is very clean. Have become a stove cleanning expert over the years.
Clean stove once a month every month in heating season.
Problem: Distribution Blower air speed seems low.
In Stove Mode, and Room temp mode. Air flow output seems low when dial set to high. In Low speed mode air flow is very,very low.
Replaced Distribution blower 3 years ago. [It just died then]
Today Replaced Distribution blower again today. Still same low blower speed symptom.
What are a few trouble shooting tips I can try from here.
Could it be the ESP Temp Probe. Cleaned it. It seemed clean before I cleaned it today.
No Blockages.
Could it be a bad Blower with the same symptom from the dealer ?
Can a blower be tested outside the stove. [hooking it up to AC maybe ?]
Could it be the Circuit board that controls the whole stove. Has anyone ever had this same symptom ?
Is the Circuit board hard to change ? How much would a circuit board cost.
Help me Mister Wizzard.......It's getting colder.
Thanks
mj
Starts fine, Flame is sharp and crisp, stove is hot.
Stove is very clean. Have become a stove cleanning expert over the years.
Clean stove once a month every month in heating season.
Problem: Distribution Blower air speed seems low.
In Stove Mode, and Room temp mode. Air flow output seems low when dial set to high. In Low speed mode air flow is very,very low.
Replaced Distribution blower 3 years ago. [It just died then]
Today Replaced Distribution blower again today. Still same low blower speed symptom.
What are a few trouble shooting tips I can try from here.
Could it be the ESP Temp Probe. Cleaned it. It seemed clean before I cleaned it today.
No Blockages.
Could it be a bad Blower with the same symptom from the dealer ?
Can a blower be tested outside the stove. [hooking it up to AC maybe ?]
Could it be the Circuit board that controls the whole stove. Has anyone ever had this same symptom ?
Is the Circuit board hard to change ? How much would a circuit board cost.
Help me Mister Wizzard.......It's getting colder.
Thanks
mj