Softwood Pellet Problem

I was having a pellet sliding down the hopper with the Lake Region junk pellets I was using last year and found by waxing the insides of the hopper with a good automotive wax the problem went away.

I went over mine with Scotch Brite pads first and then waxed them but the pellets still won't slide. I've used both softwood and hard wood pellets. Same result. The hopper floor on the Sante Fe gets up to about 145 degrees while the one on the Castile is 90. Don't know why there is such a difference but neither one lets the pellets slide down easily. Just not steep enough of an angle. We need a vibrator on there.

tjnamtiw said:

I went over mine with Scotch Brite pads first and then waxed them but the pellets still won't slide. I've used both softwood and hard wood pellets. Same result. The hopper floor on the Sante Fe gets up to about 145 degrees while the one on the Castile is 90. Don't know why there is such a difference but neither one lets the pellets slide down easily. Just not steep enough of an angle. We need a vibrator on there.

Click to expand...

I get in too much trouble around here so I not going to make any suggestions were to get a "vibrator" from. :gulp:

nuYooper said:

That is why I tried the Pledge furniture polish as it is also a wax.

Click to expand...

I find the Pledge furniture polish stays sticky, that is why the suggestion of a good automotive wax, this stuff drys and will not be sticky after it's applied.

Yea, I knew it would be a matter of time on the 'vibrator' theory..... :vampire:

Was having that issue with my stove also. I vacuumed the hopper and then applied foil tape over the beads of silicon around the auger cover , also over the spot welds as they were a little rough. Then sprayed dry graphite and wiped it down. Been a month with no problems and believe me when i forget to top it off and it runs empty, Its Empty!

nuYooper said:

That is why I tried the Pledge furniture polish as it is also a wax.

Click to expand...

Pledge is not a wax, but an oil based polish. Heating it only adds to it's "stickiness". I used Scotchbrite to scour the hopper and tested for slipperyness, found the overspray from the paint was still creating too much friction, so I lightly sanded to a dull sheen. Used "Butcher's Wax" to coat the hopper and have not needed to touch it for three years. You could use any very hard wax, but make sure it is a very light coat. A friend after waxing added Dry-Cote a teflon based lub, but I didn't have any and haven't missed it.

I don't think the "softwood" part is the problem. Irregular size and coarseness of the pellets pay a greater part. Also, loosely pouring the pellets and not packing the hopper have a lot to do with preventing bridging. Another suggestion from another forum member years ago was to add a cup of vegetable oil to a bag of pellets to "slick then up". May be a good use for the oil left from your deep fried Christmas Turkey.

Another suggestion from another forum member years ago was to add a cup of vegetable oil to a bag of pellets to “slick then upâ€. May be a good use for the oil left from your deep fried Christmas Turkey.

Click to expand...

I can just visualize all the dogs and other animals in this guys neighborhood haning around just outside his pellet exhaust vent salivating and staring due to the odor coming from it.