Need instructions on igniter replacement Breckwell P23I

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.
unplug stove open left side panel two 5/16 bolts loosen bolts swing open door. look inside locate igniter near bottom of stove below auger motor. loosen Allen screw holding the igniter in place slip out unplug wires from connectors install new igniter tighten set screw plug in connectors to the wires you disconnect from the old one . close side panel plug in and fire up the stove.
 
Thanks, allen screw was the key item I couldn't see. Ended pulling out the housing by removing 2 bolts, then found the allen screw.
 
Status
Not open for further replies.

Similar threads

J
Air switch replacement Breckwell P23i
Replies
2
Views
287
The Pellet Mill - Pellet and Multifuel Stoves
Joerg
J
Iburnslow
Harman Accentra Replacement Distribution Motor
Replies
0
Views
358
The Pellet Mill - Pellet and Multifuel Stoves
Iburnslow
Iburnslow
N
Harman Accentra 52i auger replacement
Replies
1
Views
715
The Pellet Mill - Pellet and Multifuel Stoves
Montecarlossfan
M
manofstihl
Replace Dauntless damper gasket
Replies
4
Views
343
Vermont Castings
manofstihl
manofstihl
Donn Fletcher
Harman XXV replaced Distribution Blower - now won’t fire
Replies
6
Views
748
The Pellet Mill - Pellet and Multifuel Stoves
Iburnslow
Iburnslow
Top Bottom
Back