I wasn't sure if I needed to get rid of Oxygen in my pressurized system untill recently getting my wife to measure it with a DO probe from her work. It measured 0.8mg/L, american boiler manufacturer association suggests 0.04max and another source says less than 0.1mg/L for hot water systems.
My system has a few air vents at high points and a scoop, I was hoping that would be enough as I had read that some rusting and high temps would get the remaining Oxygen out.... apparently it dosn't get enough out.
Which would be a better investment; an air eliminator (spirovent ect.) or chemicals?
Which do people on here use with success?
My system has a few air vents at high points and a scoop, I was hoping that would be enough as I had read that some rusting and high temps would get the remaining Oxygen out.... apparently it dosn't get enough out.
Which would be a better investment; an air eliminator (spirovent ect.) or chemicals?
Which do people on here use with success?