Englander 25pdvc blower change

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.
mike56

mike56

Member
Aug 13, 2010
166
broad brook,ct
First of all, i hope everyone here had a nice thanksgiving, I am going to change both blowers on my Englander today, it is a 2006 and from what i have learned the blowers are only good for 5 to 6 years so i thought now would be a good time to change them instead of in the middle of winter, has anyone changed both blowers at the same time and did you notice that the stove was quieter?
 
No comment on the noise. But make sure to keep the old blowers/motors. Do a thorough cleaning (blow out dust bunnies from motor) with a compressor and then oil well and keep on the shelf (just in case).

I have a new combustion blower for my Quad on the shelf. For when the factory one goes South. Wont change it till its bad though.

Have you noticed any performance related issues? If you replace them and dont notice a difference. I would put the old ones back in, until they finally go to the Motor Haven in the sky. My 2 cents.
 
No performance issues yet, they just seem louder then last year. (no place to oil them) I have cleaned them each season, they are over 5 years old, so I'm going to install the new ones and keep the old ones for spares.
 
I was also wondering do they make a room blower with more cfm?? Also can you try different manufacturer of blowers??
Just a thought??
 
Yes i do know what to look for, these have no oiling ports cheap china made blowers the new replacements from englander are made in mexico, i read somewhere that the quality on these is better, only time will tell.
 
Status
Not open for further replies.

Similar threads

CRR-VINNY
Englander 25-PDVC another low heat issue
Replies
6
Views
432
The Pellet Mill - Pellet and Multifuel Stoves
ericofmaine
ericofmaine
Donn Fletcher
XXV Distribution Blower replacement question
Replies
0
Views
467
The Pellet Mill - Pellet and Multifuel Stoves
Donn Fletcher
Donn Fletcher
tlc1976
Silicone rubber gasket for room blower
Replies
0
Views
659
The Pellet Mill - Pellet and Multifuel Stoves
tlc1976
tlc1976
K
England's Stove Works 55-SHPEPI Auger Issue
Replies
2
Views
636
The Pellet Mill - Pellet and Multifuel Stoves
klang46er
K
J
Quad 1200i Convection Blower Won't Run
Replies
3
Views
552
The Pellet Mill - Pellet and Multifuel Stoves
js312
J
Top Bottom
Back