Separate names with a comma.
I have had the outside air kit for about a month. Basement install, exterior 25' chimney.
It has helped slightly with "cold flue" low pressure...
The fuel is always suspect, I agree. Funny the Husq LS oil has a fuel stabilizer in it.
I cant imagine that would have hurt it..but.
Not every 5100s customer has been taken care of, especially without some provoking.
My situation is described in this thread....
I find it hard to blame the dealer, its like blaming the waiter for your uncooked food.
As was said most are Mom and Pop outfits making a...
Next time I'll run it richer..even though the manual says 50:1
This EPA B.S. is just causing problems for us.
It probably wont...
Prof - that's a good solution from your dealer.
I am just looking for them to fix the saw
BTW they sent the piston and cylinder to NY. then to...
It's really just a problem with the 5100s.
Other threads suggest that the 2008 year was a bad run
with the common failure being scored pistons.
Yes, I am contacting the NHDOJ on Monday.
"Pretty common issue for them unfortunately."
Exactly, I don't understand why they are trying to...
Sorry to say I bought a 5100s.
Long story short, I used it 4 times and it died. I read the manual and followed it to the letter.
The "Elg" is basically a turbulator.
Its got a secondary air path underneath the firebox.
This results in a venturi like effect. Thus the high...
The Jotul 121 is the "Belle of the Ball" for sure!
I personally think they wasted their time with 118 CB, its too small.
Jotul should have made...
The Elg is a great stove. It takes a 24" log easy and burns about 7 hours when full.
Additionally, I have lined the stove floor with firebrick....
I didn't see it mentioned regarding chimney height. The manual states a minimum chimney height of 15' from the base of the appliance.
FYI, you should probably get that curtain out of there.
Good to know about the flue plate swap. I find the Elg, like most pre EPA stoves throws the heat better with a flue damper. Best of luck.
You will end up placing the flue collar on the top after removing the blocking plate. Additionally, you will need
the "smoke hole cover" to cover...
The baffles will warp (as you noticed) over time changing the shape. Great solution you came up with. I'll
give it a try on my shop 121. I Place...
Did you solve this problem?
I did find NFPA mentioned on a re-read. the Manual states to refer to
NFPA pub no. 211 for the venting and must be installed in accordance with...
The Manual states nothing about any heat shields. Was NFPA around in 1979?
There was an optional heat exchanger which required 22 guage steel for...
I have the manual. It states side dimension clearance (A) = 44 3/4"
Back dimension (x)= 38".
I use this stove as my primary heat source in not...