Separate names with a comma.
The gaskets stick to the housing and the motor flange.
Remove the nuts and the bolt and wiggle the motor til it comes off.
The gasket it going...
WE have a 2300 ft ranch and utilize 3 stoves placed throughout the house to efficiently heat it
We have a large Whitfield in the family room...
Work never ends.
Just me and the other half beating on this thing.
YARD WORK WASSSSAT ??
We are very rural and use a rear PTO mower on the tractor to keep the...
Totally fried now.
Started this back in mid May when we decided to do the remodel.
A few tid bits left to get finished, but pretty much...
More pics of the new
When the piccy of the hearth was taken there is still a bit of hand touch up work and things to be finished on the project....
Been off doing my thing.
We contracted a new roof for the house, and then with all the dust from the roof getting thumped and worked on we...
Got it all finished yesterday.
This was a seriously challenging project, but ended well.
Now it needs a new home to call it's own.
Been off for the past few days, but we had a storm move in and a cool rain last night.
One stove on this morning.
What Jackman said
If Dougies get over $200 we start screaming.
Butttttt, that said, when you add transportation charges to get the stuff across...
Not ready yet.
A few hot days then back to feeding the fire.
Yesterday the stove was on until early afternoon, then off through the night.
The picture labeled H and J really show the extent of the "Butchery" that some will go to in trying to fix stuff.
I saved the fan box, and the...
And still more pix
And more pix
Recently got the bug to do some stove stuff to keep from going stir crazy.
Bought a little Whit off Craigs list and dragged it home last week....
Weather has been ON AND OFF
The past few days were in the 80's F
This morning its back to April weather and the little stove is doing it's thing...
I came back to this post as I recently picked up some bad boards in the hopes of refurbishing them.
The components are all standard off the shelf...
When was the last time the combustion fan was pulled out and cleaned ???
We have 2 of these here at the ranch and have had since 1993.
Does the unit have the metal fire pot ???
Likely it does.
The clay pots did...
Can I ask you, Why a new stove ?????
There are tons of good used ones available at good prices.
Simply go through a used one and put it in top...
Many stoves have a phase controller in the control board that will adjust the fan speed when the feed rate is raised or lowered.
If you want to...
My bet is that when the glass was re-positioned with the new gasket that the stress points were likely in a slightly different spot and when it go...
More goodies came in the mail Monday, so I was able to verify hole sizes and finish drilling the panel.
Got the drilling done and decided to do a...
Went out today after breakfast and stopped by Fry's Electronics.
Got a few terminals and some other tidbits.
Went to work on the self contained...
Got some goodies today and did a test on the phase control again with a 24k ohm resistor soldered in parallel to the pot to give an absolute...
That is a draft booster fan for the prodigy 2
It was handy and had spade terminals on it to facilitate quick use in my phase control...
Sorry to say, never seen one.
Not that it would not be useful in some situations, but likely not a big enough call for it to tool up for it.
All quiet on the Western Front.
The new control panel is looking good and getting closer.
The bulk of the drilled holes through the face of it are...
That's an interesting though.
Should not do that, but, I suppose anything is possible.