Separate names with a comma.
Setup today for the Northeast Biomass Heating Expo 2016
Will try to post pictures during the event
Free Registration to Northeast Biomass Heating Expo: Act Now!
Go to the NH Wood Energy Council website and click on "conference scholarship...
This is maybe the key to what you are looking for:
Check out the NYSERDA presentation under presentations:...
Is this a residential or commercial building ?
it has a great efficiency of 87.9%, ............ according to their website.
That tells me it is a NO go for me.
These stays run from top to bottom
Below a picture of an ASME rated tank (section VIII) with flat bottoms (Hydronic Specialty Supply)
You can clearly see the stays, and there are...
These tanks are non-pressurized, correct?
This type of construction will not be able to hold 5 psi, unless there are some stays inside to keep it...
I just wasted 20 minutes reading this post
And yes, we love pictures!
Assume 1 cord of wood has 21,000,000 BTU available
Then $200 / 21,000,000 * 1,000,000 = $9.52/miljonBTU
1 kWh = 3,412 BTU
1,000,000 / 3,412 *...
As long as these tanks have the original ASME nameplate attached to the tank body they are good to go.
But, if there were nozzles welded to these...
For what it is worth, EPA test results and real world usage is like black and white ..... .
In my opinion, thermal storage makes everything less complicated.
Maybe a little bit more money upfront, but operation of the wood boiler will be...
Very intrigued by the combustion concept.
Make sure you burn very well seasoned firewood and have anti-condense protection on your boiler
The manual of your wood furnace and/or label should tell you what chimney pipe to use
This is a link to the manual:...
one valve brand specifically designed to protect against condensation is the Caleffi ThermoMIX.
See attached product sheet with schematics
What are you trying to achieve .... ?
Nice tractor (the wright color too = Windhager red), nice barn, nice metal roof, nice cord wood drying setup, nice generator, nice woods and a...
You can find a list of cord wood boilers and pellet boilers that are EPA qualified in this link:
Windhager BioWIN260S manual feed (bagged pellets)
26 kW or 89,000 BTU/hr
Modulates from 100% output to 30% of max output
Day hopper holds around...
... and the CB rep probably also said that you can burn fresh cut wood in it.
Ruuuuuuuuuuuuuuuuuun ... and don't look back
Update on my end;
I had 3 companies over; Solarcity, Astrum (ahat is Energy Solar Direct) and Trinity Solar.
And I also had one phone consultation...
Hi Newburner, can you please list some of the other websites / forums on solar PV ?
2.4 ratio start to stops is EXCELLENT !
I would really leave the BioWIN at the 10 kW setting.
I don't remember if we did a heat load calculation...
pros & cons of leasing?
what are reputable companies to contact?
Check out this technical presentation on the Renewable Heat NY website:...
When the bulk pellet hopper runs empty, the BioWIN suction turbine will try between 20 to 30 times to get pellets into the day hopper.
Are you aware that NH has a 30% rebate (up to $6,000) for a fully automatic pellet boiler?...
A Windhager BioWIN runs on average $25,000 to install
MassCEC has a $12,000 rebate right now for the installation of a fully automatic pellet boiler with a min of 3 tons of pellet bulk...