I have almost the identical vent installation as you. My termination cap is about 16" from the siding and no issues with soot. I do have the...
I built the one in my avatar out of 2x2's (spaced no more than 12" apart), with a layer of 1/2" OSB screwed to the top, then a layer of 1/2" cement...
Ha, ha, yeah exactly what I meant - I know the feeling and have done that unfortunately too many times. A phone call might be worth it to the...
Just a thought and I could be sending you on a goose chase, but have you tried an automotive parts store like NAPA, Auto Zone, etc.?
"Outside Air Kit" - pulls air for combustion from outside house, rather than pulling it from the room where the stove is located.
Cool. Thanks for the info!
I have not tried mine yet, but I did add a couple extra screws and silicone for good measure. After vacuuming yours out, do you use any sealant...
Smoke Show beat me to it...see his post above - he's got a nice shot of the vacuum tee adapter. Have not tried it yet since my stove has only...
The part that my thumb is touching fits up inside the 4" pipe; I guess that would be considered the male end. The little lip at the bottom fits...
Here's the pic...
If you decide not to do the vacuum clean-out thing (you can just make it out on my avatar - little 90 degree fitting at the bottom), you likely...
I just installed this about a week ago...no issues whatsoever. The DT pipe is great; slid together really easy...it's pre-lubed and has a nice...
Thanks for that info! I may end up buying a skid of the Ribs then and see how the first ton goes.
I see in your signature that you are burning Rib Mountains...how you like them so far? I just installed our stove this weekend and bought a few test...
Just finished our hearth pad last night. Didn't take any build pics, but attached a photo if it helps you get a general idea. Basically a 40"x40"...
That sounds like a good way to go - did the Selkirk pipe require any sealant at all between sections, or was the built in seal good enough? I see...
Yeah, that is one thing I wondered about with OAK...is it needed for better combustion/stove performance, or simply to prevent sucking in cold air...
Great info - thanks! Did the 3" give you any problems - is that why you switched? Thimble for 3" vs 4" should be about the same dimensions, and...
Newb here that just purchased a Lennox Winslow pellet stove. Plan is to install in basement family room (where we spend most time watching TV)....
Separate names with a comma.
