1. Welcome Hearth.com Guests and Visitors - Please enjoy our forums!
    Hearth.com GOLD Sponsors who help bring the site content to you:
    Jotul Cast Iron Stoves
    Woodstock Soapstone Stoves
    Hearth and Home (QuadraFire and Harman Stoves)

Search Results

Search Again
Page 1 of 4
  1. Swaybar
    Post

    P43-Hot

    Same with me...I will ride until the salt goes down, then I am done! Got a new 2013 Ultra Limited Thursday, and am hoping to get a few miles on...
    Post by: Swaybar, Oct 17, 2012 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  2. Swaybar
    Post

    How Long Have You Been Heating With Pellets

    Oct. 1999,
    Post by: Swaybar, Sep 29, 2012 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  3. Swaybar
    Post

    Harman P68 - Deal or Not

    "the lady wont move off of 2600 says that's what she owes on it" Only paid off $1,00 in 2 years? Must be a high interest financing, or cc and...
    Post by: Swaybar, Aug 25, 2012 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  4. Swaybar
    Post

    Whats the profit on a ton of pellet ?

    The OP's original question was - whats the profit on a ton of pellets? That will vary greatly. The mark up may be $40-$100 a Ton, but the...
    Post by: Swaybar, Aug 14, 2012 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  5. Swaybar
    Post

    Harman room sensor ID

    There is a thermistor inside the shrink wrap. do not block the end, it will be slow to respond
    Post by: Swaybar, Mar 11, 2012 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  6. Swaybar
    Thread

    HUD secretary agrees to Sen. Collins’ request for new rules for pellet boilers

    http://bangordailynews.com/2012/03/02/energy/hud-secretary-agrees-to-sen-collins-request-for-new-rules-for-pellet-boilers/?ref=latest Until now,...
    Thread by: Swaybar, Mar 6, 2012, 2 replies, in forum: The Pellet Mill - Pellet and Multifuel Stoves
  7. Swaybar
    Post

    I hate this Harmon

    Try Rocky's on Route 3 in Augusta, they usually have one burning.
    Post by: Swaybar, Feb 11, 2012 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  8. Swaybar
    Post

    Maine Pellet Manufacturers Meet With USDA

    I hope they don't give the manufacturers subsidies. If they are going to spend taxpayer money to help support the industry, the money should go to...
    Post by: Swaybar, Feb 11, 2012 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  9. Swaybar
    Post

    Dealer troubles

    I will vouch for Rocky. Bought a Firefox there in the late 90's, been getting parts ( and a new P43), there since!
    Post by: Swaybar, Feb 1, 2012 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  10. Swaybar
    Post

    harman P43 pellet stove won't light

    Same set up as the P43 as the P61. I had the same issue at least three times with the igniter getting caked with ash and not allowing the pellets...
    Post by: Swaybar, Jan 29, 2012 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  11. Swaybar
    Post

    Pennington Nature's Heat burn like poop

    Burned 2 tons so far...burned 3 tons last year. No problems here. P43 will burn just about anything!
    Post by: Swaybar, Jan 9, 2012 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  12. Swaybar
    Post

    Pellet/Boiler for stem heat??

    I have not seen a steam pellet boiler. Harman PB 105 is a hot water boiler. A steam boiler requires some serious temps. At 3.6 Bar (52.2 psi)...
    Post by: Swaybar, Jan 9, 2012 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  13. Swaybar
    Post

    New P61A "dirty burn" - 6 blinks. `

    A 6 blink control board status indication is caused by poor or incomplete combustion. The Automatic Ignition circuit board has the ability to track...
    Post by: Swaybar, Dec 17, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  14. Swaybar
    Post

    Raised Ranch Home - Pellet stove advice/pros/cons wanted!

    I have a raised ranch as well..Stove is in center of lower level facing doorway to upper level. It heats whole house all winter. Bedrooms in corner...
    Post by: Swaybar, Oct 14, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  15. Swaybar
    Post

    Pellet's on clearance at Sam's Club $3.61 per bag (WV)

    $197 Rockland Me Home Depot
    Post by: Swaybar, Sep 28, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  16. Swaybar
    Post

    My problem with stores keeping their pellets outside.

    HD here will replace any bags you say were bad, don't even need to bring em back, just say 10 bags were wet or too much sawdust and they will replace...
    Post by: Swaybar, Sep 25, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  17. Swaybar
    Post

    Harman P43 combustion blower

    If you can't figure it out let me know, I will pull mine tomorrow and take a look.
    Post by: Swaybar, Sep 24, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  18. Swaybar
    Post

    Stove Chow @ $197

    Grabbed 4 tons stove chow at Rockland HD today, while there wifey bought new washer and dryer...comes out to about $700 a ton. She stays home next...
    Post by: Swaybar, Sep 24, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  19. Swaybar
    Post

    Home Depot's Latest Wood Pellets in Salem NH

    http://www.pressherald.com/news/pellet-production_2011-02-13.html Pellet production heats up again Maine’s plants gear up – as do job prospects...
    Post by: Swaybar, Feb 13, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  20. Swaybar
    Post

    Stove company bankrupt

    I thought they were expensive
    Post by: Swaybar, Jan 14, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
Showing results 1 to 20 of 72 Next >
Search Again
Page 1 of 4