I have a St.Croix stove changed parts and ready for an quieter stove.. I have seen the Ravelli Francesca burning and like how quiet it was. Is this...
Are you referring to the kit that puts the combustion blower outside the house? If so, I personally have never heard anyone here that used one...
Just wanted to know if anyone was using the outside combustion kit..
After reading everyone's messages I did something different last year. I pulled the motor and pumped grease through the hole the motor shaft was...
To me it looked like a great place top dry out your welding rods.
Convection motor with a psc motor (one that uses a run capacitor) will draw less amps then a shaded pole motor that is used on most small fans.
Did you make the storage box?
I think you started something here.
From Colchester, New England pellets burn ok but loads of ash, clinkers big time and demands opening OA alittle Country...
Same stove, same pellets, same problems even down to the fire brick. Behind the fire chamber on top jam a stiff wire and go back and forth, up and...
I have a St. Croix Hastings with the same problems associated with the center back panel. I will be trying out next week materal designed for oil...
That seems sensible.... :coolsmile: Chris[/quote] I can't get any more specific then that.
I teach H.V.A.C. and latent for latent heat.
Craig, I use to install Stelrad wood/coal boilers in thew 80s. Is the picture in the reply one of them?
I was a coal burner before wood pellets. One thing about coal is that coal generates acid from the by-products of combustion. The acid will work in a...
One additional (green) idea would be to use the dryer durring the day time to gain on sunlight factor. Cfm replacement based on infilteration air for...
Boot dryer by the stove. I use my wifes Confidance USA Model # ? exercise bike. Handle bars are good spot to slide boot over force them open to dry....
The noise is from the gear box assembly (vg motor). I have squeezed Napa high temp greese directly into the gear box by seperating the motor from...
I would like to know if someone has been burning pellets with the multi fuel setup. I have some of the nosies associated with the vg motor/gear...
Has anyone changed out the basic chamber for pellets and converted over to the multi fuel (for corn and other seeds) chamber ? My understanding is...
Separate names with a comma.