1. Welcome Hearth.com Guests and Visitors - Please enjoy our forums!
    Hearth.com GOLD Sponsors who help bring the site content to you:
    Jotul Cast Iron Stoves
    Woodstock Soapstone Stoves
    Hearth and Home (QuadraFire and Harman Stoves)

Search Results

Search Again
Page 1 of 4
  1. bookpile
    Post

    How to wire 2 wire Accentra Insert fan into 4 wire stove

    That never occurred to me, a lot better than the alternative I was considering. Thanks a lot, we just enjoyed dinner in front of the pellet...
    Post by: bookpile, Jan 2, 2013 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  2. bookpile
    Post

    Distribution fan on Harman Accentra

    Did you ever figure out how to put it in? I just got mine. I was worried about the electrical part. I didn't realize you'd have to rip the enter...
    Post by: bookpile, Jan 2, 2013 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  3. bookpile
    Post

    How to wire 2 wire Accentra Insert fan into 4 wire stove

    Actually, even though there are four wires coming from the fan, only two are hooked up. No problem there, but how on earth do you install this fan?...
    Post by: bookpile, Jan 2, 2013 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  4. bookpile
    Thread

    How to wire 2 wire Accentra Insert fan into 4 wire stove

    Well after making noise for a couple of months my distribution fan on my 2006 Accentra insert finally died. I thoroughly cleaned it but it only runs...
    Thread by: bookpile, Jan 2, 2013, 3 replies, in forum: The Pellet Mill - Pellet and Multifuel Stoves
  5. bookpile
    Post

    First major cleaning Harman Accentra Insert

    Might want to check into a lint eater brush. Ours goes up through 1.5 stories and I was shocked at the amount of ash that comes pouring out of the...
    Post by: bookpile, Oct 13, 2012 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  6. bookpile
    Post

    Harman Accentra FS Combustion Blower Problems. Please help!!

    My stove had the exact same symptoms. However it was not a problem with the combustion blower, the ignitor was stuck on continuously. The heat that...
    Post by: bookpile, Dec 18, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  7. bookpile
    Post

    hot water

    If it's so "simple" why don't you help him out and provide all the ones you found. It's a legitimate question, I haven't seen any yet.
    Post by: bookpile, Dec 11, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  8. bookpile
    Post

    Searching for pellet dealers in NJ or Eastern PA

    Ray's Greenhouse in Telford sells Barefoot.
    Post by: bookpile, Dec 4, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  9. bookpile
    Post

    Kill A Watt meter

    Or you might be surprised at how much electric your stove is using. If you ignitor is permanently stuck on that is. (I discovered it with a Kill A...
    Post by: bookpile, Nov 15, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  10. bookpile
    Post

    Harman Accentra Insert Power Consumption

    The problem is finally fixed. This spilled into another thread but the ignitor was stuck on the entire time, which was the source of the high power...
    Post by: bookpile, Nov 13, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  11. bookpile
    Post

    Harman Accentra Insert Ignitor stuck on

    Thanks for all the help everyone. New board fixed the problem.
    Post by: bookpile, Nov 13, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  12. bookpile
    Post

    Harman Accentra Insert Ignitor stuck on

    That is exactly how I have gotten to this point. I thought my winter electric bill was ridiculous so I started checking around with the power meter....
    Post by: bookpile, Nov 6, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  13. bookpile
    Post

    Harman Accentra Insert Ignitor stuck on

    Actually that makes perfect sense. My stove seems to run forever in cool down mode sometimes, but as soon as I crack the door a little bit it will...
    Post by: bookpile, Nov 6, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  14. bookpile
    Post

    Harman Accentra Insert Ignitor stuck on

    Should also note that the ignitor is on even when the switch is in the manual position and the ignitor light is off. Would that be more indicative of...
    Post by: bookpile, Nov 6, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  15. bookpile
    Post

    Harman Accentra Insert Ignitor stuck on

    That did it, I unplugged the ignitor and it dropped from 480w to 210w. So is there anything else I check besides the circuit board?
    Post by: bookpile, Nov 5, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  16. bookpile
    Thread

    Harman Accentra Insert Ignitor stuck on

    I've been trying to figure out why my insert is drawing so much power for some time now. I think I finally figured it out. When I started the stove...
    Thread by: bookpile, Nov 5, 2011, 14 replies, in forum: The Pellet Mill - Pellet and Multifuel Stoves
  17. bookpile
    Post

    Does your LOWES charge a pallet fee ??

    My Lowe's tried that on me once. I told them I'd stand there and watch while they loaded all the bags on my truck individually. They called a manager...
    Post by: bookpile, Oct 18, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  18. bookpile
    Post

    Harman Accentra Insert Power Consumption

    Well I finally did some testing. Seems like the combustion blower is consistently drawing 330 watts. In test mode it is 480w total. With the...
    Post by: bookpile, Oct 18, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  19. bookpile
    Post

    How many of you move a ton a pellets on your truck? Do you have a full ton truck?

    I think what should be taken away from this thread is that 1/2 ton, 3/4 ton, and 1 ton are antiquated terms that should have stopped being used 40...
    Post by: bookpile, Oct 2, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  20. bookpile
    Post

    Harman P43 combustion blower

    I'm not sure about the P43, but the Accentra insert I have is gasket less. If all else fails check the owner's manual: "The gasketless seal relies...
    Post by: bookpile, Sep 25, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
Showing results 1 to 20 of 72 Next >
Search Again
Page 1 of 4