I figured when initially looking at the schematic I would see power on the blue wire and I am getting it on the black when the control calls for feed.
Door and glass gaskets all appear to be good. If I need to check any other gaskets I am going to have to tear the stove down to do so unless there is...
Still need to replace the hopper seals there is something else going on with the stove. The stove did not seem to be getting enough pellets and...
I think I am going to replace the hopper seal and the screw seals. I wetted down the hopper seal again and did the painters tape over the screws and...
Ok so after putting water on the hopper lid seal and holding it down by pushing down on it we started running again. I put some painters tape around...
FIgured as much but thought I should note that. This is the second switch I have tried and with a section of hose connected to it and a slight amount...
Cleaned the back of the stove also and have thrown a jumper in to bypass the pressure switch and everything works fine. The tee is what I callled the...
Forgot to mention no blikling lights on the control board either.
Cap on the drop leg? If so the thing is crazy tight but I will see if I can turn it a little more. No switch on the hopper lid.
The stove was cleaned at the begining of the season and we used it a short time before it quit on us. I did a cleaning and tried it again thinking it...
Forgot to mention that if I install a jumper to remove the pressure switch from the circuit the stove works fine.
New to the site but have been nosing around here for a couple of years on and off to cleaning tips etc. I have a Harman Accentra that quit working...
Separate names with a comma.
