It's been iffy for weeks, but today my EKO Controller Stop switch failed, which means I can't get it out of Fuel Mode. Anyone else have this problem...
Based on info in this forum, when I installed my Eko 60 I set the boiler pump launch temp at 170ºF. Now that I've had 10 months of burning under my...
I just added a new set of radiant slab loops to my boiler. The closely spaced tees and everything had been there since install. The manifold consists...
So the EKO 60 made it through the winter, gradually working worse and worse. The weather here was such that I couldn't give it the break I needed to...
So things have been going pretty smoothly with the EKO 60 since I got it online in January. After a few hiccups it has worked well. Love that I can...
So I'm thinking my Taco 0010--IFC 3-speed just isn't cutting it as the circulation pump on my boiler loop. My head is running around 12-13 feet,...
So I'm trying to decide if my flat panels are operating as efficiently as they should. Knowing next to nothing about balancing hydronic systems I'm...
Good News! EKO 60 is online & functioning. It's below freezing outside & I've been fighting leaks all day BEFORE heating things up. Got them all...
Getting really close to filling the system. Another day of sweating fittings and then an air pressure test and then....and then..... do I just fill...
Just checking to see if it's cool to put the pex lines coming off the manifold out of the top, with the flow controls on the bottom, or is there some...
So I thought I could put cutting edge technology into a 160 year old house...... It appears I have hit a major snag with my Eko60 installation....
So I'm finally getting my head around my primary/secondary unpressurized system..... Had almost all the things right in my head except for the fact...
So here's my wacky thought...... Use DHW to feed in as supply side make up water. Traditionally this hasn't been done for the obvious...
So as I'm putting panels in each room, linked to a manifold via home runs, I am perplexed by the 3 or so solutions to how to regulate the heat which...
I'm trying to figure out the most reasonable & cost effective way to feed my rad. manifolds from the boiler/storage tank loop....Alternative Hydronic...
So after looking at a dizzying array of diagrams and reading countless theories & methods I am still stumped as to how best to plumb my Eko 60 in an...
My storage tank is going to be in the cellar under the house. My boiler is 100ft away in an attached barn. Can anyone recommend a good--and by good I...
It's been a few months since the Eko 60 arrived. Unfortunately it had to sit outside until I could get the radiant slabs in the barn poured. It is...
I am a total newbie at this Gasification boiler stuff. Back in Feb of this year I spoke with two local experts who have installed tons of systems and...
I'm new to the forum, but have been reading/learning as much as I can before installing a new system in our 1840's farmhouse. I'm currently making...
Separate names with a comma.
