Thanks for the reply, Camfan! I have looked into the stainless liners, as I would really like to do this for safety and efficiency, but I was told...
No worries, Dave! Thanks again for the info and reassurance! I also agree about the wealth of knowledge on the boards here. I've learned a lot...
Dave, Thanks for the response! Like you, I've been burning wood for a little over twenty years on my own and also grew up with wood heat in my...
Once again, I'd like to thank everyone for their advice about the baffle plate. It looks like it's going to work out fine, but yesterday I...
Thanks for the picture, Dave! That's pretty much the same angle I was going with, but the picture clears it up. I haven't had a chance to...
Well, I picked up the baffle plate from the welding shop and have a couple firebricks cut on what I think is the correct angle for the install, but...
Thanks again, Coaly! That makes sense. I was thinking along the same lines as far the fluctuation in pipe temps, but I think I've read too much on...
Coaly, I should be picking up my baffle for the Baby Bear this week from the welding shop (They only had 1/4" in stock and had to order the 5/16")...
Thanks, CamFam! I will definitely look into getting one of those. That's basically a pre-fabricated version of what I was referring to as a...
I'm actually planning to stop by a local welding shop this afternoon on my way home to get a steel plate for the baffle and hopefully get it...
Thanks again to Pen and Coaly for all the advice! I currently have the Baby Bear hooked up and burning and it's putting off some nice heat. I...
Thanks, Pen and Coaly for the responses. Coaly, as you mentioned, I've noticed how tight the elbow fits over the outside of the collar on the rear...
Hello, I'm new to the forum, but there seems to be some great information here! I recently acquired a Fisher Baby Bear, in excellent...
Separate names with a comma.