I did the same thing. I cut wound up needing to shorten mine so when I had it cut apart, I took to the car wash and washed out with the degreaser....
I do not think that is the case. The reason is that until recently i had WAY to much air going in. I had the two upper baffles into the wood...
I have continually been increasing the number of coals in my lower chamber. I am normally a pretty logical guy but for some reason, until reading...
I obviously have not ran it long enough yet to see if it increases my run time on a load but the reduction is coals/ash is very nice change. I will...
I just went to my fab shop and they cut me a 1/2 thick plate with the nozzle hole cut out of it that will cover the whole nozzle brick. Then I...
I have a Biomass 40. I had noticed that I was getting ALLOT of coals in the refractory every time I went to fill it. It would take about 2 1/2...
does anybody happen to know the approx dimensions of the "nozzle plate" or the flat part that has the nozzle hole cut in it at the bottom of the...
Separate names with a comma.
