1. Welcome Hearth.com Guests and Visitors - Please enjoy our forums!
    Hearth.com GOLD Sponsors who help bring the site content to you:
    Jotul Cast Iron Stoves
    Woodstock Soapstone Stoves
    Hearth and Home (QuadraFire and Harman Stoves)

Search Results

Search Again
Page 1 of 2
  1. dingees
    Post

    Harman pellet comsumption???

    you also need to run the room fan setting on the H for high ,also more even heat out put in the stove mode and fan on high
    Post by: dingees, Feb 5, 2012 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  2. dingees
    Post

    Pellet Stove may have caused housefire

    it says the fire started in the garage, was the stove installed in the garage, if not and it was in the house part then how would the stove start...
    Post by: dingees, Feb 5, 2012 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  3. dingees
    Post

    Problems with Harman PB105

    the vacuum switch is there for several reasons and one being that it will shut the auger off if #1 there is a lack of draft if the doors are left...
    Post by: dingees, Jan 23, 2012 in forum: The Boiler Room - Wood Boilers and Furnaces
  4. dingees
    Post

    Harman Accentra insert distribution blower

    have u ever had the fan out or cleaned the dust and lint out of it
    Post by: dingees, Jan 6, 2012 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  5. dingees
    Post

    Harman p38 making black ashes

    feed rate should be at 3 or 4 and let the esp control the amount of fuel needed to heat. if u let it run on the lower setting then the fire will...
    Post by: dingees, Jan 4, 2012 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  6. dingees
    Post

    harman accentra will not turn off

    the red esp will only work with the control board # 5- 20-05886, if he replaced the old board then make sure this is the new seris, the # will be on...
    Post by: dingees, Dec 31, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  7. dingees
    Post

    harman accentra will not turn off

    make sure feed rate dial is not turned to the test mode as then it will run in a on off mode all the time.
    Post by: dingees, Dec 31, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  8. dingees
    Post

    harman accentra will not turn off

    # 5 dip switch should be turned ON
    Post by: dingees, Dec 31, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  9. dingees
    Post

    harman accentra will not turn off

    What were the readings with the new esp and the new board? another esp may be needed
    Post by: dingees, Dec 31, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  10. dingees
    Post

    harman accentra will not turn off

    probably your esp prope is bad and is stuck in the heat mode and is still calling for heat, if it is still feeding pellets. When he came , what was...
    Post by: dingees, Dec 31, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  11. dingees
    Post

    Harman Accentra Red Lights Off No Power

    u dont need to pull the insert,to check fuse, unplug power cord from wall outlet. there are scews holing the control board in place, if u take them...
    Post by: dingees, Nov 20, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  12. dingees
    Post

    Harman P43 Air Flow / Left Side Burn Issues

    has the ignitor ever been changed or has the ignitor ever been taken out of the stove?
    Post by: dingees, Nov 20, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  13. dingees
    Post

    Need a little help with Whitfield Advantage IIT please

    one fuse for the whole board there is the on off switch for the auger it is what usually goes new board ,like a new stove better heat than their...
    Post by: dingees, Nov 15, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  14. dingees
    Post

    Tale of Two Pellet Stoves - Need some advice

    thruthly there is no photo eye. but some stoves do have one to see the flame to keep it going ie.Whitfield/lennox) may be due to low draft setting...
    Post by: dingees, Nov 15, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  15. dingees
    Post

    Tale of Two Pellet Stoves - Need some advice

    page 5 of the install manual and also on the label on back of stove it will state that in mobile homes and manufactured homes do not install in a...
    Post by: dingees, Nov 14, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  16. dingees
    Post

    Maintenance access/space behind my Mount Vernon: In and Out Regrets

    do not put yourself thru the agony of standing on your head or becoming a condurtionist trying to maintain or fix the stove , the easier u make it...
    Post by: dingees, Nov 13, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  17. dingees
    Post

    Harman P43 Air Flow / Left Side Burn Issues

    looks like air flow problem. there are I think 5 rows of air holes in the burn pot, the bottom or back 2 are hard to see from the front. a drill bit...
    Post by: dingees, Nov 13, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  18. dingees
    Post

    Test Mode on a Harman

    the test mode is exactly that . it is to bypass the controls to actually see if things are working, so when some one calls the dealer up to say my...
    Post by: dingees, Nov 6, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  19. dingees
    Post

    Harman Accentra Insert Ignitor stuck on

    is is your control board. something is stuck and will not shut the ignitor off, as the esp gets to its design temp to turn off the ignitor. you will...
    Post by: dingees, Nov 6, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
  20. dingees
    Post

    Anyone know whats wrong with my Pellet Stove?

    if u run it on # 1 all the time the flame and hottest part of the fire is right at the end of the auger .if a higer srtting can be used then the...
    Post by: dingees, Nov 6, 2011 in forum: The Pellet Mill - Pellet and Multifuel Stoves
Showing results 1 to 20 of 33 Next >
Search Again
Page 1 of 2