I have oiled the convection blower multiple times each year. This was the first season that I pulled the motor to clean the blades. The combustion...
By end of heating season last year motor was sounding a bit loud. I took out convection blower in the fall, oiled it and cleaned the blades, after...
Stove was out when I got up this morning and would not restart, the auger was not turning. When I got home from work I checked for auger jams, tested...
I have an older gf55 so my board is a little different then yours. Default trim setting is 4 and combustion is 2. I usually run mine on hi/lo with...
I think Timberheats are rebagged Dry Creeks. The plant address on the bag is the same. They seem similar to Stove Chow to me, decent heat but a...
Away at my daughters soccer tournament this weekend so I did not have a chance to respond. The girls to 1st place so it was a good trip. If I go 1ft...
I was not very clear on what the current vent pipe setup was. The only photo's I had were of the first install. They had to redo pipe setup to meet...
Here is the installation manual pertaining to vent requirements. Thanks
5ft is recommended not required. Outside chimney is for oil furnace. I did not have many (any) options on where to place the stove inside the house.
Smoke Stove is located on 1st floor. There is a 3inch adapter pipe that goes straight through outside wall. Adapter pipe is 18 inches. At least 5ft...
Smoke, Thanks for reply. I have pictures of 1st install which was direct vent which did not meet code. Installer returned, put on a clean out tee...
[ATTACH][ATTACH]
When my stove was installed they ran the vent pipe horizontally, parallel with the house then vertically so the termination point would be 4 ft from...
Separate names with a comma.
