My gasser seems to run at about 400F most of the time measured by a stack probe. As it start to buildup fly ash in the tubes it will creep up to...
The best comprehensive radiant floor site I have seen is http://www.radiantdesigninstitute.com/. For his opinion of the aluminum plates see...
After 13 months, I finally got my Tarm and storage tank online. Using many peoples input from this board and others, I created a simple design that...
Update: I decided not to fabricate my own coils and bought them instead from "Tom of Maine" and they are working like a charm. I just got my boiler...
I like that -- wait and see how it all works out. Less to do for now! Thanks! Rurik
I should add that my furnace in my basement not an exterior version. R
How do any of you handle combustion air? If my house is relatively tight I don't have an adequate way of feeding combustion air to my wood boiler. Or...
HR, The male 1.25" NPT fittings seem to extend nicely into the straight threads on the Tarm Solo 30. So would I be OK if I used teflon tape and...
Here's a PDF version of the plans for the FEMA downdraft wood gasifier: http://wood-gas.com/wp-content/uploads/2008/12/woodgas12.pdf
The Resol units look just the Stiebel-Eltron SOM 7 unit I have.
For insulation against the rim joist I used foil-bubble-foil against the rim joist, caulked the edges and then put 4" of cotton bat insulation. I put...
The Steca looks like tne "one controller to rule them all!" Rurik
So if I used a setpoint controller like a Tekmar 157 with Taco 007 pump already have I would have the same as the Delta-T pump capabilities but...
So to summarize a few of the good ideas I have heard: - small pipes are good but make sure I have adequate flow - variable speed delta-t pump is...
I have lurked on this board for a while and thanks to all for the incredible amount of knowledge shared here. However I now have questions but first...
Separate names with a comma.
